RipMap.

RipMap shop guides

How to plan a plywood cut layout

A plywood cut layout shows where each part can fit on the stock you have. Start by separating incompatible materials, then allow for the space the blade removes and the edges you cannot use.

Start with actual stock sizes

Group parts by material and thickness before combining them. A 3/4-inch cabinet side and a 1/4-inch back may both be birch plywood, but they cannot come from the same sheet. List full sheets and measured offcuts separately. If an offcut has a damaged corner or an unusable edge, enter only the clean rectangular area you can use.

Leave room for kerf, trim and grain

Kerf is the width removed by the blade. Two 24-inch blanks side by side need more than 48 inches if a cut runs between them, even before any edge trim. Use the actual blade kerf and usable sheet size in your plan. For visible cabinet doors or ends, check grain direction before allowing the layout to rotate a part.

Decide what to pull and what to buy

Say your plywood list includes two 23 1/4 × 34 1/2-inch sides and a 21 × 28 7/16-inch shelf. A clean 22 × 40-inch offcut is wide enough for that shelf in this orientation, but not for either side. Planning the shelf on the offcut could leave more of a full sheet for the sides and bottom. Check the real offcut, its grain and your trim allowance before relying on it.

Review the plan before cutting

RipMap’s Layouts view groups diagrams by material and thickness. The diagram shows numbered parts and usable offcuts, alongside a list of the parts on that sheet.